K-2000-DVA - Viking Electronics

Customer Service (715) 386-8861

Mass Notification System Voice Alarm Dialing or Store Caster Announcements from up to Eight Inputs

Find A Distributor

Product Details

Viking’s K-2000-DVA is a fully programmable multi-input, multinumber auto dialer and digital announcer, designed for emergency and non-emergency message notification. The K-2000-DVA has eight dry contact inputs, each of which can dial up to eight 32-digit phone numbers and play a message up to one minute in length specific to that input. The messages can be recorded locally or remotely.

When configured as an alarm dialer, the K-2000-DVA has call progress detection capability with normal and fast busy, call pickup, CPC and ring-no-answer detection. The K-2000-DVA can also be set up as a store caster (no dialing), for on-site promotional or assistance announcements.

The K-2000-DVA can be programmed with a touch tone phone or a PC with a serial port connection.


Alarm Dialer:

  • Security / burglar / fire alarm notification
  • System alarm or equipment malfunction notification
  • Operating temperature warning notification
  • Contacting personnel via numeric pagers

Store Caster to provide assistance (i.e.: “Customer assistance needed in aisle 13…”) or promotional announcements in:

  • Department stores
  • Grocery stores
  • Hardware stores
  • Gas stations, etc.


  • Non-volatile memory, no batteries required
  • Stores up to eight 32-digit phone numbers per input (sixty-four 32-digit numbers total)
  • 8 minutes of record time (1 minute per input)
  • Programmable message repeat counter
  • Programmable lap counter
  • Eight inputs programmable normally open or normally closed and enabled or disabled
  • Programmable ring delay for remote programming and alarm polling
  • Programmable qualifier timer for each input (time for an event to be qualified as an alarm)
  • Programmable resume timer for each input (time following reset for input to become active again)
  • Call progress detection
  • Programmable ringback limit for call progress
  • Remote security and access codes
  • Store caster mode
  • Local or remote programming and recording
  • RS-232 port for programming via a PC
  • Compatible with the Viking RC-2A and RC-3 remote DTMF controllers
  • Phone numbers may be programmed as pager numbers (no voice message played)
  • Programmable hookswitch flash before dialing
  • Line level input for loading pre-recorded messages into the unit


  • Power: 120VAC / 12VDC 500 mA UL listed adapter provided
  • Dimensions: 8.3″ x 6.3″ x 1.8″ (211mm x 160mm x 46mm)
  • Shipping Weight: 2.25 lbs (1.02 kg)
  • Operating Temperature: 32°F to 90°F (0°C to 32°C)
  • Humidity: 5% to 95% non-condensing
  • Talk Battery: 12VDC
  • Touch Tone Dialing Speed: Normal – 120ms on / off, Fast – 50ms on / off
  • Minimum CPC Detection Time: 320ms
  • Total Message Record Time: 8 minutes
  • Sampling Rate: 64K (equivalent)
  • Input Detection Time: 80ms with Qualifier Timer set to 0
  • Resolution Qualifier Timer: 1 second to 18 hours
  • Resolution Resume Timer: 1 second to 18 hours
  • Connections: (1) RJ11 jack for telco connection, (2) 3.5mm jacks for 600 Ohm audio output and record in, (1) 9 pin RS-232 for PC connection, (13) cage clamp screw terminals


  • FCC Part 68
  • FCC Part 15